Used 67 Chevelle body/project for sale in El Paso, TX

I'm sell one of my projects the 67 Chevelle. It's a project and needs to be complete. I have replaced the trunk floor, replaced the truck lid, added mini tubs, both outter fender wells ( extra room was made for tire clearance), both quarter panels, both door skins, replaced the metal dash, several metal patches on the floor and replaced one toe board. Has a new radiator support and both new front fenders wells. Everything was welded and smoothed out where needed.
(Places need to be finished with Bondo both fenders and hood.)

The frame has been boxed, narrower from the rear and reinforced. The rear has a 4-link set up with air bags, the 12 bolt rear has been narrowed with moser axles installed, 9" ford bearing ends, all bearings / seals replaced and has 373 gears with posi unit.
(What's missing, I'm missing the rear dis brake kits.)

Front end has all cpp uppers, lowers, dis brake set up spindles, rotors and springs, gas shocks and a new set of tie rods.
(What's missing, a new gear box.) I have the original.
I have some pictures of the work as it was being done.

Inside I had to redo the tunnel to make room for the drive shaft.
The only interior I have are a set of new style bucket set.

I have a new set of glass for this car.
New SS grille and light buckets
I didn't cover all the work that has been done or all the parts that have been replace. To much to cover on this page.

The reason I'm sell, I also have a SB c-10 72 I'm building and I need to sell one of them to be able to finish the other (hopefipully) this summer. Note: people don't understand the amount of work and money that's involved in building a project cars. If you know about cars and you are interested in this 67 we'll all the hard work is done.
NOTE. It going to be a pro-touring car not a race car.

As far as tires only the one to roll it go with it.
NOTE included in the car.
I have a rebuild 1967 bbc 396 standard bore, factory 10:1, steel crank, comp cam, and a 4-speed tanny and performance clutch , for an extra amount if interested.

For the 67 chevelle as is and what ever parts I have for it I'll take $18,500. OBO As I stated I want the money to finish my other project. Please, I don't need to sell it so be nice.

If you want the 396 and tranny I'll take $6,500
Serious buyers only. I will not do business on the phone. And NO scammers, please.
Title in hand
show contact info